Longshine LCS-WA3-50 Manuel d'utilisateur télécharger pdf (Page 10)

Wireless 11n Access Point

Chapter 2 Installing and Using Wireless Access Point

This chapter provides a step-by-step guide to the installation and configuration of the Wireless AP.

We suggest you go over the whole chapter and then do more advanced operation.

2.1 Connecting this AP to your network

This Chapter provides a step-by-step guide to the installation and configuration of this wireless

access point.

 Connect the power adapter with the connector end to the power connector in the rear panel

of the device and the plug end to an appropriate outlet.

 Connect the LAN port with RJ-45 cable to:

1. A broad band router to allow wireless clients to connect to WAN.

2. A switch to allow wireless clients to communicate with wired LAN.

3. A computer directly to use the computer configuring this AP.

Note: You have to configure the network settings of this AP to be communicable with your router,

switch or computer first. To change the default network settings of the AP, please refer to “LAN

Interface setup”.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 32 33

Pas de commentaire

Longshine LCS-WA3-50 Manuel d'utilisateur Page 10